Skip to content

Reviews / Frigidaire

Frigidaire 50 Pint with Pump and Wi-Fi

Frigidaire's own paperwork gives two different wattages for this machine, and the certification record gives a third. That makes it the clearest demonstration on this site of why a nameplate is not a running cost.

By Scooter M.

Published

Last updated

#adThis page contains affiliate links. We earn a commission on qualifying purchases, at no cost to you, and it never changes a ranking. Full disclosure.

A wall socket photographed straight on

The short answer

The ENERGY STAR certified entry for the FHDP5033Y1 computes to 490 W average draw, and that is the figure for running cost. Frigidaire's own documents disagree about the nameplate: its US specification sheet states 115 V, 5.5 A and 620 W, and its Canadian product page states 115 V, 8.8 A and 470 W. Use the higher figure for sizing a circuit.

Three numbers, and only one is for your bill

The same machine, three figures from three documents
FigureWhere it comes fromWhat it is for
620 W, 5.5 A at 115 VFrigidaire's US specification sheetA nameplate maximum. Use the higher published figure when working out what can share the circuit
470 W, 8.8 A at 115 VFrigidaire's Canadian product pageAlso presented as a nameplate - but 8.8 A at 115 V is over 1,000 W, so this pair does not reconcile with itself
490 W computedENERGY STAR certified entry: 49.95 pt/day at IEF 2.01Running cost. The average draw at the DOE test condition - the number to multiply by hours and your rate

All three retrieved 2026-09-16. We are not claiming either Frigidaire document is the wrong one. We are pointing out that they disagree, that one of them disagrees with its own amperage, and that neither is the figure a running-cost calculation should use.

This is the useful lesson of this particular machine. A nameplate is a maximum with everything energized at once - compressor, fan and pump - and makers are neither consistent nor careful about how they print it. The certified average comes from a defined test procedure and a public record anyone can check. When the two disagree, the one with a test procedure behind it wins.

A wall socket seen straight on
The nameplate is the circuit number. The certified average is the bill number.

Frigidaire FHDP5033Y1, certified

(490 W / 1000) x 12 h x $0.1834/kWh = $1.08 per day

0.490

kWh per hour

$32.83

per month, 12 h/day

$65.65

per month, 24 h/day

Rate is the US residential average of 18.34 cents/kWh from the EIA Electric Power Monthly, June 2026. Yours will differ - use the calculator.

Quick picks

#ProductBest forDrawPrice
1
Frigidaire 50 Pint Dehumidifier with Pump and Wi-FiFrigidaire 50 Pint Dehumidifier with Pump and Wi-FiFrigidaire's own documents give two different wattages for this machine and the certified record gives a third - which makes it the clearest case on the site for trusting the computed average over any printed figure.
Seeing why a nameplate is not a running cost490 W
$254.35View on Amazon

#ad Price as of October 17, 2026. How we are funded

2
Frigidaire 50 Pint Dehumidifier with Wi-FiFrigidaire 50 Pint Dehumidifier with Wi-FiFrigidaire's current no-pump 50-pint: certified by exact model number, Wi-Fi equipped, and a 2.7 gallon bucket that is among the largest of any 50-pint unit we track.
A Frigidaire with a drain below it488 W
$308.14View on Amazon

#ad Price as of October 17, 2026. How we are funded

1

Frigidaire

Frigidaire 50 Pint Dehumidifier with Pump and Wi-Fi

Best for: Seeing why a nameplate is not a running cost

Frigidaire 50 Pint Dehumidifier with Pump and Wi-Fi

Frigidaire's own documents give two different wattages for this machine and the certified record gives a third - which makes it the clearest case on the site for trusting the computed average over any printed figure.

Average draw

490 W

Computed from the ENERGY STAR certified entry for Frigidaire FHDP5033Y1 - the same model number as this listing: 49.95 pt/day at IEF 2.01 L/kWh. Frigidaire's own figures do not agree with each other: its US specification sheet states 115 V, 5.5 A and 620 W, while its Canadian product page states 115 V, 8.8 A and 470 W. Those are nameplate figures, not averages, and they do not reconcile - use 490 W for running cost.

What is good

  • The retail model number is exactly the certified one, so the 490 W figure is a direct match rather than a family estimate
  • Pump discharges upward into a sink or out of a window, with bucket and continuous-drain modes as well
  • Stated to keep working down to 41F, which matters in an unheated basement in shoulder season
  • Wi-Fi with the Frigidaire app, plus Alexa and Google Home

What is not

  • Frigidaire's two published wattages disagree - 620 W and 470 W - and neither is the running-cost figure
  • No pump lift or hose run is stated on the listing or on either Frigidaire page we checked
  • The Amazon listing itself is sparse; the useful detail lives on Frigidaire's own pages

Who it is for

Someone who wants a pump and Wi-Fi from a maker with a certified exact-model record, and who will size the circuit from the higher of the maker's figures.

Skip it if

Skip it if your pump route is long or tall. Frigidaire states no lift, where GE and Quilo state 15 feet in writing.

We have not tested this unit. Every figure above is quoted from the manufacturer or computed from published certification data, and every source is linked. How we work.

2

Frigidaire

Frigidaire 50 Pint Dehumidifier with Wi-Fi

Best for: A Frigidaire with a drain below it

Frigidaire 50 Pint Dehumidifier with Wi-Fi

Frigidaire's current no-pump 50-pint: certified by exact model number, Wi-Fi equipped, and a 2.7 gallon bucket that is among the largest of any 50-pint unit we track.

Average draw

488 W

Computed from the ENERGY STAR certified entry for Frigidaire FHDD5034Y1 - the same model number as this listing: 49.71 pt/day at IEF 2.01 L/kWh. Frigidaire's Canadian product page states 115 V, 8.8 A and 470 W; those figures do not reconcile with each other and are nameplate rather than average values, so 488 W is the running-cost figure.

What is good

  • Exact certified model match, so the 488 W figure describes this machine rather than a sibling
  • 2.7 gallon bucket - roughly ten hours of condensate at full rated capacity if you ever run it without a hose
  • Continuous drain, three fan speeds and operation down to 41F
  • Wi-Fi and the Frigidaire app for scheduling and remote control

What is not

  • Gravity only. The drain must be below the machine
  • The Wi-Fi depends on Frigidaire's app remaining supported
  • Frigidaire's own published wattage and amperage do not agree with each other

Who it is for

Someone with a floor drain who wants a certified, well-documented 50-pint unit and has a use for scheduling.

Skip it if

Skip it if the only drain is above the machine. That is the one job a gravity unit cannot do, whatever else it has.

We have not tested this unit. Every figure above is quoted from the manufacturer or computed from published certification data, and every source is linked. How we work.

The model number, which now matches exactly

This page used to carry a caveat: the retail listing was the W1 suffix and the certified list carried Y1, so the wattage mapping was by revision family rather than exact. The live listing is now the FHDP5033Y1 itself, so that caveat no longer applies - the 490 W figure describes the machine the buy button points at.

The rest of it

  • Down to 41F. Frigidaire states low-temperature operation to 41F, which matters in an unheated basement in spring and autumn.
  • Three drainage modes. Bucket, continuous drain, or the pump discharging upward into a sink or out of a window.
  • 1.9 gallon bucket. On a pump model that is the fallback if the pump ever stops - about seven hours of condensate at full rated capacity.
  • No published pump reach. Neither the Amazon listing nor either Frigidaire page we checked states a lift or a hose run. GE and Quilo both state 15 feet on their pump models. Pump lift and distance.
  • Wi-Fi, the Frigidaire app, Alexa and Google Home. Useful for scheduling and alerts, and dependent on the app remaining supported.

Who should buy something else

Anyone whose pump route is long or tall, because Frigidaire commits to no figure for it - GE's pump model states 15 vertical feet and a 16 foot hose. And anyone who does not need the pump at all: Frigidaire's no-pump 50-pint is certified at 488 W and carries a larger 2.7 gallon bucket. The Frigidaire without a pump. For the wider connected field, including the only unit whose listing explicitly promises maintenance alerts, see the best smart dehumidifiers and the LG PuriCare reference.

FAQ

Questions

How many watts does the Frigidaire FHDP5033Y1 use?
The ENERGY STAR certified entry computes to 490 W average draw, which is the figure for running cost. Frigidaire's own nameplate figures disagree - 620 W on its US specification sheet and 470 W on its Canadian product page - so use the higher one for sizing a circuit.
Why do the wattage figures differ?
A nameplate is a maximum with everything energized at once and makers print it inconsistently. The certified figure is the average draw at the DOE test condition, measured under a defined procedure. When they disagree, use the certified average for running cost.
How high can this Frigidaire pump water?
Frigidaire does not state a lift height or a hose run on the listing or on the product pages we checked. It describes the pump as discharging upward into a sink or out of a window, which is the intended use rather than a specification.
What happened to the Frigidaire FHDP5033W1?
That listing is no longer sold on Amazon. The FHDP5033Y1 is the revision the ENERGY STAR list certifies, it is the same 50-pint pump and Wi-Fi platform, and it is the model this page now covers.

Sources

Sources

Read next

#adThe Dry Index earns a commission on qualifying purchases made through links on this site, at no extra cost to you. It never changes a ranking. Full disclosure.